≡
PIC-PG3
Parallel port PIC 8/18/28/40 pin devices programmer
Price | 16.95 EUR |
---|---|
10 - 49 pcs | 15.26 EUR |
50 - 10000 pcs | 13.56 EUR |
FEATURES
- PIC-PG3 is programmer based on D.Tait's parallel port design. To operate it needs external power supply 12-15VAC or 16-18VDC. It supports all 8/18/28 and 40 pin PIC microcontrollers which allow serial programming. PIC-PG3 have connector and cable for ICSP programming and can be used to program all PIC-PxxB prototype boards.
- The supported devices depend on the current version of ICPROG software.
- There is also LINUX support for this programmer
- Dimensions 75x58 mm (3x2.3") + 30 cm (12") ICSP cable
DOCUMENTS
- PIC-PG3.pdf - Users Manual
- Sparkfun's PIC-PG3 tutorial in Spanish translated by our South American reseller Ingeneria MCI
- NOTE: The programmer may not work with low power serial interfaces - i.e. laptop or notebook serial ports. USB to serial cables have also not been proven to work.
- PIC-PG3 European Declaration of Conformity
HARDWARE
SOFTWARE
- ICPROG from Bonny Gijzen freeware for programming many PICs, sometimes it doesn't work on some computers read here why.
- PICPgm freeware PIC programming software by Christian Stadler supports many PICs and is officially supporting our PIC-PG1/2 and PIC-PG3
- PICALLW - SHAREWARE software by Bojan Dobaj
- FREE software by Nigel Goodwin
FAQ
- My computer has no LPT port. Can I use a LPT to RS232 converter with PIC-PG3?
- No, the USB to LPT converters add delay due to the USB nature and this will mess up the programming timings. If you want a USB programmer consider the PIC-KIT3.