(small) error in user's manual for Olinuxino-micro

[flavigny]

Hello,
in section 6.4
I read: "The GPIO pins  are led out on a separate 40 pin connector"
il is bviously a sentence related to -maxi board.
regards.
PO.

[LubOlimex]

Thanks for the feedback, this is now fixed.

Best regards,
Lub/OLIMEX

[Kean]

Also note on page 31 in the GPIO pinout, pin 29 of CON1 is listed as "3.3V_E" but is actually GND.

[LubOlimex]

Thank you, Kean

The table is now fixed. Pin 29 of CON1 is indeed GND.

Regards,
Lub/OLIMEX