LIME2 board

Started by anatolewilson, July 04, 2024, 12:15:25 PM

Previous topic - Next topic

anatolewilson

Hi all,

My LIME2 board is working fine with A20-OLinuXino-bullseye-base image if I connect it through HDMI, but 7" and 4.3" olimex LCDs are not working at all. No video, no light.

I'm using the 0.5 pitch 40 pin cable, and power up the LIME2 board with a 5V 2A power source.

Any suggestion? Thanks!

LubOlimex

First make sure that you are using the proper connector at the back of the display. Make sure it is labelled LIME2 (e.g. do not connect the cable to the LIME one). Then make sure orientation of the cable between the board and the LCD is proper, trace first pin. It is bad if you connect it in reverse. Once hardware is cleared, power the board when you boot the image run the script to change the video output:

olinuxino-display

Select the entry corresponding to your display save and reboot.

For more info download and check this document:

https://github.com/OLIMEX/OLINUXINO/blob/master/DOCUMENTS/OLIMAGE/Olimage-guide.pdf
Technical support and documentation manager at Olimex