RT1010Py-DevKit

[TS]

There is a Power1 pushbutton on the board, which goes to ONOFF Pin (21) of the RT1010Py board. So far, I could not find out how to use it, it seems to be unsupported despite the name.
Does anyone have any success with this?

Thank you!

Thomas

[LubOlimex]

Hardware connection seems alright, but in the software onoff can be configured in different ways. Maybe try holding the button down (in case it was not set to debouce). Refer to the table at page 13 to read more about onoff:

https://www.nxp.com/docs/en/data-sheet/IMXRT1010CEC.pdf

[TS]

Yes, you were right. Holding the Power button for 5 Seconds will turn the system off, while just tipping the button turns it on. Great!
Sorry for my late reply, as I did not get a notification, that a reply is waiting.

Thank you!