PIC LCD Help :)

[kik0]

Hi can some one help me
https://www.olimex.com/Products/PIC/Development/PIC-LCD/

I have a problem. I need to make this board to control a DC motor. But i have a problem when i program the code every thing is working but when i swich off the bord then turn it on the sorce is not on the bord any more. Can some one help me. I remove the buzzer and use CCP2 pin for PWM. Any ideas what may couse the problem ? The config off the pic, the compiler ? PLEASE HELP 

[LubOlimex]

Hey kik0,

Are you sure you are using the Flash memory to write down your code? Maybe you have used some RAM debug configuration?

By the way CCP2(S31) is used by the LCD also.

Best regards,
Lub/OLIMEX