PIC32-T795 - programming problems

[slayer99]

Hello. I've just bought PIC32-T795 board and i have a strange problem programming it. It's working fine as long as i'm in debug mode. But after i put it in release mode it is not executing program - even simple led blinking  I've been working on few different PIC32 processor platforms and i never had such problem before. I'm using MPLAB X and ICD 3 hardware. I've checked the same software on different PIC32 processor board and it works just fine. Any clues??

[olimex]

this usually happens when you setup your linker to place your code in RAM
make it to place your code in Flash and try again