LIME2 EXT4-fs error

[Alli]

Hi,
i have a Lime2
when i flash rom to it first time it boots without problem, but when i shut down properly and reset
i get
"EXT4-fs error (device nande): ext4_lookup:1050: inode #2: comm zygote: deleted inode referenced: 16" error and then I/O errors like
"Could not stat dex cache directory '/data/dalvik-cache': I/O error".

and it stays in loop at android logo. is this a software issue, how could i fix this. after reflash it boots once without problem again then loop again
i am using olinuxino-a20.tgz .

Regards
Alli

[Alli]

Hi,
when i flash this official android image to lime2
https://www.olimex.com/wiki/A20-OLinuXino-LIME2#Android
it also does not boot
log is like this
is something wrong with board ?

Regards

[       0.486] battery enough
[       0.487] power_start=0x00000000
[       0.487] pre sys mode
[       0.490] key value = 0
[       0.492] recovery key high 40, low 4
[       0.514] show pic finish
[       0.514] load kernel start
[       0.533] load kernel successed
[       0.533] start address = 0x4a000000
[       1.030] power exit detect
[       1.030] usb exit detect
[       1.030] jump to
[       1.033] set retry default value: [       1.036]  0x00000020[       1.038]  0x00000020[       1.040]  0x00000072[       1.043]  0x000000bf[       1

U-Boot 2011.09-rc1-00000-geceb6aa-dirty (May 06 2014 - 12:52:25) Allwinner Technology
CPU:   SUNXNB1 : init ok
3480 MiB
In:    serial
Out:   serial
Err:   serial
--------fastboot partitions--------
-total partitions:11-
-name-        -start-       -size-     
bootloader  : 8000          8000       
env         : 10000         8000       
boot        : 18000         8000       
system      : 20000         140000     
data        : 160000        100000     
misc        : 260000        8000       
recovery    : 268000        10000       
cache       : 278000        140000     
databk      : 3b8000        80000       
private     : 438000        8000       
UDISK       : 440000        28c000     
-----------------------------------
bootcmd set setargs_nand
Hit any key to stop autoboot:  0
set retry default value:  20 20 72 bf
[NAND]dumy read,chip 0

Starting kernel ...

[    0.772284] something wrong in chip id
[    1.455917] something wrong in chip id
[    1.460452] something wrong in chip id
[    1.469560] something wrong in chip id
[    2.652513] init: width = 800
[    2.655840] init: height = 480
[    2.659281] init: s.st_size = 1536000
[    2.693584] EX[    2.740379] init: buffer : /dev/block/nande
[    4.194871] init: do_umount: /data
[    4.198800] init: do_umount error = Invalid argument
[    4.376600] EX[    4.420313] init: buffer : /dev/block/nandh
[    6.125179] init: do_umount: /cache
[    6.129232] init: do_umount error = Invalid argument
[    6.181092] init: start format /dev/block/UDISK
[    6.186398] init: wait for format /dev/block/UDISK
[    6.186617] init: fork to format /dev/block/UDISK
[    7.726837] init: format /dev/block/UDISK ok
[    7.734001] EX[    7.790334] init: buffer : /dev/block/nandi
[    8.637451] init: do_umount: /databk
[    8.641604] init: do_umount error = Invalid argument
[    8.679780] init: cannot find '/system/etc/install-recovery.sh', disabling 'flash_recovery'
[    9.134257] something wrong in chip id
[   11.692211] android_usb: already disabled
[   11.696994] init: using deprecated syntax for specifying property 'sys.usb.config', use ${name} instead
[   11.708907] init: using deprecated syntax for specifying property 'sys.usb.config', use ${name} instead
shell@android:/ $