Help with Hardware

[andyh747]

I'm trying to build an ESP board for integration with a Somfy RTS system highlighted here:

I'm completely new to doing this so forgive the stupid questions.
I'm going with the ESP32-POE-ISO board and case.  I need to connect an CC1101 transceiver to the UEXT connector.  I'm using the following transceiver:

Is there a specific interface I can use which will simply allow these to plug together so the correct pinout is connected from the board to transceiver?

Thanks for any help.

[LubOlimex]

What exactly is the transceiver? Information is missing after ":"...

[geertv]

Hi, seems I am exactly looking into the same thing.
The RF module is the CC1101, which is available as a board E07-M1101D-SMA compatible with ESP32.
This should be the pin reference for E07-M1101D:
Pin   Description      ESP Pin
1   GND         GND
2   VCC         3v3
3   GDO0 - This is the TX Pin   GPIO 04
4   CSN         GPIO 13
5   SCK         GPIO 14
6   MOSI         GPIO 15
7   MISO         GPIO 16
8   GDO2 - This is the RX pin   GPIO 36

Would a UEXT module be an option ?

[LubOlimex]

GPIO36 is not GPIO regarding the ESP32 board, it is only input hence the name in our documentation GPI36. So maybe swap 3 and 8.